MZ@ !L!This program cannot be run in DOS mode. $<թRթRթRԩRPԩRRichթRPEL!   @@ 4.rdatap@@.rsrc @@ؐW T.rdataT.rdata$zzzdbg p.rsrc$01p".rsrc$02h(@ (@ X!pr        ( 8 H Xp" #$&(P,)n,T1B5\8`9*9MUI,{w\Ԧ梴xҥ MUIen-US No Error.Unspecified error.Unsupported video format.Device is still playing.Unprepared header. Sync error.Device already in use. Capture device was not detected.)Capture driver is not installed properly.Palette creation error.Structure size incorrect.Param1 invalid.Param2 invalid."Configuration parameter 1 invalid."Configuration parameter 2 invalid.Flags parameter invalid. Error 13.Unsupported function.Out of memory.Device is already in use.Invalid device ID.Invalid handle.Invalid error number.No buffers are available.#Memory conflict / problem detected.I/O address conflict detected.DMA conflict detected.&Interrupt conflict / problem detected.;Driver cannot run in Standard mode, requires Enhanced mode. Capture Start Capture End%s Out of memory!File '%s' exists -- overwrite it?Error opening palette '%s'Error saving palette '%s'Error saving frame '%s'avipalCannot open '%s'3Select OK to start capture of video sequence to %s."Hit ESCAPE or click to end capture.An error occurred while trying to run VidEdit."The file '%s' is a read-only file./Unable to write to file '%s'. Disk may be full.CThere is no space to create a capture file on the specified device.PA Set File Size$SaveAs: %2ld%% Hit Escape to abort.UError: Cannot open the wave input device. Check sample size, frequency, and channels.&Error: Out of memory for wave buffers.#Error: Cannot prepare wave buffers.Error: Cannot add wave buffers.Error: Bad wave size.*Error: Cannot open the video input device.'Error: Out of memory for video buffers.$Error: Cannot prepare video buffers. Error: Cannot add video buffers.Error: Bad video size. Error: Cannot open capture file.7Error: Cannot write to capture file. Disk may be full.FError: Cannot write to capture file. Data rate too high or disk full.PAError while recording(Error: Unable to initialize for capture.^Warning: No frames captured. Confirm that vertical sync interrupts are configured and enabled.Warning: Using default palette.#Error: Unable to access MCI device.!Error: Unable to step MCI device.9Error: No audio data captured. Check audio card settings.'Error: Unable to draw this data format.'Error: Unable to initialize compressor.?Error: Audio data was lost during capture; reduce capture rate.MError: Audio data was lost during capture; try capturing without compressing.PA Live windowOverlay window$Setting up for capture - Please wait'Finished capture, now writing frame %ldBuilding palette mapComputing optimal palette %d frames %ld framesCaptured %ld framesCapturing audio.Captured %ld frames (%ld dropped) %d.%03d sec.]Captured %d.%03d sec. %ld frames (%ld dropped) (%d.%03d fps). %ld audio bytes (%d,%03d sps)PA=Captured %d.%03d sec. %ld frames (%ld dropped) (%d.%03d fps)4Dropped %ld of %ld frames (%d.%1d%%) during capture.PA0=rtlPA4VS_VERSION_INFO 98 98?StringFileInfo040904B0LCompanyNameMicrosoft CorporationZFileDescriptionAVI Capture window classn'FileVersion10.0.14393.0 (rs1_release.160715-1616): InternalNameAVICAP32.DLL.LegalCopyright Microsoft Corporation. All rights reserved.JOriginalFilenameAVICAP32.DLL.MUIj%ProductNameMicrosoft Windows Operating System> ProductVersion10.0.14393.0DVarFileInfo$Translation PADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADx

Windows NT KPTV 6.2 build 9200 (Windows Server 2012 Datacenter Edition) i586